beautypg.com

Analog in, Analog out – Avid HD OMNI Preamp, I/O, and Monitoring Pro Tools HD Series Interface User Manual

Page 32

background image

HD OMNI Guide

28

Analog In

The Analog In page of the Hardware Setup dia-
log lets you set the Reference Level for the phys-
ical analog inputs on HD OMNI. You can also
apply a limiter to each of the four analog inputs.

Reference Level

Select the appropriate

Reference Level

for each of

the four analog input channels. Input operating
levels are switchable between +4 dBu and
–10 dBV operation.

Limiter

HD OMNI provides options for limiting on each
of the four input channels. Select an option
from the corresponding

Limiter

pop-up menu:

None

Applies no limiting to the incoming ana-

log signal.

Soft Clip

Attenuates the incoming analog signal,

providing extra protection from temporary clip-
ping transients that can cause digital distortion
when they exceed the maximum input of the
unit. With Soft Clip enabled, HD OMNI sup-
ports an additional 4 dB of headroom by round-
ing off the top 4 dB to the clip point. This is use-
ful for eliminating stray transients.

Curv

Attenuates the incoming analog signal us-

ing a soft knee limiter circuit. This guarantees
super soft limiting without becoming hard, even
with large overloads on input.

Analog Out

The Analog Out page of the Hardware Setup di-
alog lets you set the Output Level for the physi-
cal analog outputs on HD OMNI. You can also
select which channels are mirrored on the back
panel TRS Outputs.

Output Level

Select the appropriate Output Level for each of
the eight analog output channels. HD OMNI
provides two options for output levels:

Speaker (+10 dBu)

Select this option for output

channels connected directly to powered moni-
tors.

Line (+24 dBu)

Select this option for output

channels connected to line-level devices (such
as an analog mixing console).

Hardware Setup, Analog In page

Hardware Setup, Analog Out page