MOVE'N SEE Personal Auto-Follow System - Manual (Page 6)

6
Charging the batteries
The complete charging of each device takes about 2 hours.
Plug the USB charger into the socket thanks to the power cord. Plug the USB cables on the USB charger.
Recharge the PIXIO robot.
Plug one of the USB cables to the plug «5V DC» at the back of the PIXIO robot. The corresponding red LED located near
the plug lights up during the recharge, and turns off when the robot is charged.
To avoid self-discharge of the robot, unplug the robot after the end of the robot charge, turn the robot ON for a few
seconds and then turn it OFF before storing it.
Recharge the PIXIO micro beacons.
Plug USB cables in each one of the micro beacons plug located behind as shown. The red LED of the micro-beacon
lights up during the recharge, and turns off when the micro-beacon is charged.
1
Recharge the PIXIO watch.
Plug the wireless charger to one of the USB cables connected to the USB charger. Just put the watch on the wireless
charger. The red LED of the watch lights up during the recharge, and goes down when the watch is charged. 1
You can also recharge the PIXIO devices with a computer. Connect the USB cable to a USB port on your computer.
1 Sometimes the red light flashes at the end of the charge. It is not a problem, the item is charged