MOVE'N SEE Personal Auto-Follow System - Manual (Page 8)

8
Setting up the PIXIO
1. Screw the robot on a tripod equipped with a standard 3/8’’ screw (check that
the motor is switched off before screwing or unscrewing the device) .
2. Screw your camera, DSLR, smartphone/tablet adaptor to the robot with the
1/4’’ screw of the PIXIO robot.
3. If you are using a supported model of camera, plug the camera and the robot
with the correct cable. There are 3 cable models depending on the camera
model:
A MULTI cable is supplied with your system. You can order an AV/R and/or a Jack
2,5mm cable at https://shop.movensee.com/
3
Before using PIXIO for the first time, you must check that the firmware of the PIXIO
is up to date (refer page 30), and check that the camera parameters kept in
the memory of the robot matches your camera model (refer page 32).
NOTICE
1
2
3
MULTI cable AV/R cable Jack Ø2.5mm cable