MOVE'N SEE Personal Auto-Follow System - Manual (Page 42)

42
TRACKING
PROBLEM CAUSE SOLUTION
The PIXIO works well at short range but
malfunctions at long range
The radio communication malfunctions
1. Verify that the beacons are not placed on
the ground. The beacons must be settled at 1m
to 2m from the ground.
2. Place the robot and the beacons following
the instructions page 12 «Micro-beacons
location» and start again the system.
The PIXIO robot always films on my side.
The beacon n°1 was not well at the center
of the frame before starting the watch, and/
or the beacon n°1 was much closer to the
camera than the whole area you want to film,
and/or the robot is not screwed enough to the
tripod
1. Re-start the system, checking that the
beacon n°1 is well at the center (right-left) of
the camera screen before starting the watch.
Check that the distance between the beacon
n°1 and the camera is similar to the maximum
distance of the area you want to film (half this
distance is a minimum).
2. Check that the robot is well screwed to the
tripod.
ZOOM / REC
PROBLEM CAUSE SOLUTION
I cannot start recording from the watch and
the zoom is fixed
1. the camera cable is not properly plugged.
2. the robot is not parameterized for your
camera model.
1. Replug the camera cable on both side.
2. Upgrade the camera parameters of your
robot. See procedure page 7
The REC stops automatically or the video is split
into many short videos.
The camera battery is empty or the camera
memory is full.
Recharge the camera battery.
Format the microSD card with the «setup
menu» of the camera.
Format the internal memory of the camera (if
applicable).