MOVE'N SEE Personal Auto-Follow System - Manual (Page 12)

12
LED blinking slowly :
recording command is OFF
LED full green :
recording command is ON
Start / Stop Recording
1. If you are using a supported camera
You can start/stop recording by pressing BRIEFLY the watch button . DO NOT
press the REC button directly on the camera.
When the camera is recording, the green LED of the watch turns ON. The watch
will blink slowly when you stop recording. If the zoom is busy, some delay might
occur when you start/stop recording. In this case, the green LED of the watch
will blink quickly until your order is taken into account.
2. If you are using a non supported camera
If you are using a camera model which is not supported by the robot, just press
«record» directly on your camera.