MOVE'N SEE Personal Auto-Follow System - Manual (Page 11)

11
Start tracking
Switch ON the camera.
Adjust the tripod horizontally and set the TILT angle of the camera by
screwing more or less the screw at the rear of the robot.
Check that the watch is OFF. Switch ON the PIXIO robot by pressing the
power button at the rear of the robot until the green light starts
to flash.
By rotating the tripod, or using robot buttons and , place the beacon n°1 at the center of the
camera screen. What is important is the right-left position of the beacon. Use the manual ZOOM on the
camera to improve the precision. A 50cm (20 inches) precision is enough.
Remain in the area and switch ON the watch by pressing its starter button until the green light turns ON.
The system initializes during about 10 to 30 seconds. When the watch LED is blinking regularly, the initialisation
is finished and the robot is tracking the watch.
unscrew to
decrease the TILT
angle
screw to increase
the TILT angle
Beacon n°1