MOVE'N SEE Personal Auto-Follow System - Manual (Page 32)

32
Configuring your PIXIO to work with your own CAMERA
By default, your PIXIO is configured to work with a SONY HDR-CX450 camera. Follow these instructions to
update the camera parameters kept in the memory of the robot.
First, download the file corresponding to your camera model at https://shop.movensee.com/ccc . The file
is meant to be opened directly on and by PIXIO robot so do not open the file directly from your computer.
Record the PIXCAM.cfg file on a micro-SD card formatted with the FAT32, FAT16 or FAT12 format (usually,
micro-SD cards with a capacity lower than 32Gb are formatted with a correct format). The file must be
saved in the root directory of the memory card, not in a sub-directory. This file is meant to be opened directly
on and by PIXIO (do not try to open it from your computer).
Check that the name of the file is PIXCAM.cfg without any ...(1) or ...(2) at the end
of the name. If needed, rename the file PIXCAM.cfg
Insert the micro-SD card in the robot slot. Switch ON the robot (do not
press any other button than the switch ON button). A few quick flashes of
the LEDs occur, and the file has disappeared from the micro SD card. The
parameters of the robot have been updated and stored in its memory.
The micro SD card goes
into the robot slot