MOVE'N SEE Personal Auto-Follow System - Manual (Page 31)

31
2. Start the UPGRADE mode
Press and hold Turn Right button on the robot, then briefly press on power button.
Release Turn Right button when the red light starts to blink.
3. UPGRADE each device
Next, you have to upgrade each element one after the other (not all
at the same time):
For the robot: Press briefly Turn Left button. The green LED blinks rapidly during the upgrade, and stops when
it is finished.
For a watch or a beacon (switched OFF before the procedure):
→ Start the « upgrade » mode: press its started button during several seconds, until its green LED blinks
→ Release the button, and press it again briefly to launch the upgrade. The green LED blinks rapidly
during the upgrade, and turns full green when it is finished.
1. Press on hold
turnRIGHT button
3. Release turnRIGHT
button when the red
light starts to blink
2. Briefly press POWER
ON
4. Press turnLEFT
button to upgrade
the robot
Is there a problem? Don’t panic....
► If the upgrade is aborted (error, switch OFF,…), you can start again the procedure.
If during step 2, the red LED does not blink:
►Check that the micro-SD card capacity is lower than 32Gb and formatted with the FAT32, FAT16, or FAT12
format;
►Check that the upgrade file is stored at the root of the card and not in a sub-directory;
►Check that the card is inserted correctly in the robot slot.