Great Plains DICKEY-john Seed Manager SE Operator Manual - Manual (Page 7)

OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
INSTALLATION AND SETUP / 5
INSTALLATION AND SETUP
CONSOLE MOUNTING
The console should be mounted inside the tractor cab in a location
accessible to the operator but does not obstruct the driving view. (
Figure 2 )
depicts a typical console mount.
Figure 2
Typical Console Mounting using the U-bracket and hardware
MOUNTING STEPS
1. Verify the rear side of the selected mounting surface is free of wiring or
other obstructions and is accessible for inserting and tightening the
mounting bolts.
2. Use the U-shaped mounting bracket as a template to mark the two
outside holes of the bracket on the selected location and drill two 9/32
inch holes. An alternate mounting method that allows the console to
swivel, requires drilling the center bracket hole only.
3. Attach the mounting bracket to the mounting surface using the ¼ - 20 x
½ inch bolts, lockwashers, flatwashers, and nuts.
4. Secure the console to the mounting bracket using the two knob
screws.
5. Insert the two rubber washers between the bracket and console.
6. Tilt console so that the J1 connector on the rear of the console is
accessible.
7. Temporarily tighten the two knob screws.
U-Bracket
1/4 -20 Nuts
and Lockwasher
U-Bracket
U-Bracket
(Preferred Mounting
Position)
Knob
Screw
Knob
Screw
1/4-20 x 3/4 Inch
Hex Bolts &
Flat washers
Console
Rubber
Washer
Rubber
Washer