Great Plains DICKEY-john Seed Manager SE Operator Manual - Manual (Page 52)

OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
50 / OPERATION
PRESSURE
This is the pressure in oz/in
2
(kPa), as measured by a pressure sensor, to a
resolution of 0.1 oz/in
2
(kPa). This function is selected by pressing the
OPERATE 2 switch until “P1” or “P2” displays in the lower numerical
display. (
Figure 60 ) shows a pressure of 12.3 oz/in 2 .
Figure 60
Pressure Display
AREA ACCUMULATOR
Area Accumulator 1 and 2 is used as a field area accumulator displaying
acres with 0.1 resolution (hectares with 0.01 resolution). Area Accumulator
3 is used as a total area accumulator with the same resolution as Area
Accumulator 1 and 2. The area calculations are based on the implement
width and distance traveled. Area does not accumulate during an ALL
ROWS FAILED condition, i. e., when the implement is raised. This function
is selected by pressing the OPERATE 3 switch until the AREA message
appears and a “1”, “2”, or “3” is shown in the lower right corner of the
display. Area Accumulator 1 and 2 is reset by pressing the START STOP
RESET switch for at least one (1) second. When a total of 9999.9 acres
(999.99 hectares) is exceeded, the decimal point shifts to the right one
place. When a total area of 99999 acres (hectares) is exceeded, it will roll
over to zero (0). (
Figure 61 ) shows Area Accumulator 1 with 1674.3 acres.
Area Accumulator 3 is not resettable.
Figure 61
Area Accumulator 1 Display