Great Plains DICKEY-john Seed Manager SE Operator Manual - Manual (Page 23)

OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
STARTUP / 21
STARTUP
SWITCHPAD OVERVIEW
The control pad buttons on the switchpad are used to control system power,
select the mode of operation, and enter implement configuration constants.
An overview of the switches follows:
ON OFF
Pressing this switch applies power to the monitor. Upon power up, the
monitor performs internal diagnostic checks, illuminates all segments of the
LCD, sounds the alarm, and determines what sensors are connected to the
system. Pressing the ON OFF switch for at least one (1) second causes the
system to power down.
ALARM
Momentarily pressing this switch silences the alarm and acknowledges the
alarm condition. Additionally, holding the switch pressed for more than one
(1) second allows the volume level of the alarm to be adjusted. As the
switch is pressed, the alarm sounds continuously and the volume level
slowly decreases to a minimum, then increases to a maximum. Releasing
the switch establishes the desired volume level.
SETUP
Press for one (1) second to enter the Setup Mode and to step from one
Setup constant to the next as detailed in the Setup Mode section.
MIN AVG MAX SCAN
Press to toggle between the MIN AVG MAX and SCAN options for
Population and Spacing.
SELECT ROW
Pressing this switch while in Population or Spacing functions freezes the
display on the current row data. Successive depressions then cause
stepping from one row to the next. In the Setup Mode, this switch allows
stepping through the rows while entering Row Status.
1 2 3 . . .