Great Plains DICKEY-john Seed Manager SE Operator Manual - Manual (Page 63)

OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
SELF TEST ERROR CODES / 61
SELF TEST ERROR CODES
The Seed Manager
®
SE Console performs a Self Test upon power up and
when selected in SETUP MODE. At the end of the Self Test, the console
will either show PASSED and cycle through all of the seed rows or the
console displays the appropriate error codes that were detected.
(
Figure 76 ) shows a complete list of all error codes that can display.
Refer to the Troubleshooting table for additional details and recommended
recovery procedures.
Figure 76
Self-Test Error Codes
Error
Code Description
E00 No Modules Connected
E01 Too Many Modules Connected on P1 or P2
E10 Too Few Seed Modules Connected
E11 Too Many Seed Modules Connected
E20 Too Few Shaft Modules Connected
E21 Too Many Shaft Modules Connected
E30X Too Few Seed Sensors Connected to Module X
E31X Too Many Seed Sensors Connected to Module X
E40 Too Few Hopper Sensors Connected
E41 Too Many Hopper Sensors Connected
E50 Too Few Pressure Sensors Connected
E51 Too Many Pressure Sensors Connected
E70 Module 8V Power Supply Too Low
E71 Module 8V Power Supply Too High
E98 Internal LCD Driver Failure
E99 Internal Bus Failure