Great Plains DICKEY-john Seed Manager SE Operator Manual - Manual (Page 26)

OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
24 / STARTUP
SETUP MODE
SETUP CONSTANTS
The Setup Mode is used to enter the implement configuration constants
which are listed in (
Figure 16 ), in the order of their presentation.
Pressing the Setup switch for one (1) second places the console in the
Setup Mode which is identified by the SETUP message on the display.
Additional messages uniquely identify the constant displayed and available
for editing at any given time.
Each constant has a fixed number of digits. Leading zeroes will display. To
change the value of a constant, use the SELECT, SET, and START STOP
RESET switches as follows:
• Initially the left most digit flashes on and off indicating it is the “selected
digit”.
• Pressing the SET switch increases the selected digit by one count.
After reaching the maximum value of nine (9), the digit rolls over to
zero (0).
• Press the START STOP RESET to set the digits to zero.
• Pressing the SELECT switch makes the next digit to the right the
selected digit.
• When the desired value is entered (or there is no change from the
original value), press the Setup switch to store the value and advance
to the next constant on the list.
• To return to the previous constant on the list, press the BACK switch. If
a value is entered which exceeds the minimum or maximum shown for
that constant in (
Figure 16 ), the alarm sounds for one (1) second, the
value of the exceeded limit appears on the screen, and the advance to
the next constant is aborted.
NOTE: To allow rapid recovery from an
entry error, it is important to
record all values of constants
on the SETUP RECORD sheet
on the last page of this manual
immediately after console entry.