Great Plains DICKEY-john Seed Manager SE Operator Manual - Manual (Page 18)

OPERATOR’S MANUAL
Seed Manager SE
11001-1359A-200810
16 / INSTALLATION AND SETUP
When hopper level sensors are connected to a Shaft Speed Module, they
are numbered relative to the position of the Shaft Speed Module on the bus.
If the Shaft Speed Module is connected to the RS-485 out of b1, the
numbering of the hopper sensors starts with this module, then continues
with any hopper sensors connected to b1, b2, etc. If the Shaft Speed
Module is connected between Material Flow Modules, any hopper sensors
connected are numbered in the order in which they are detected as shown
below.
Figure 14
Hopper Sensor Connection to Shaft Speed Module