FEC AFC1200 User Manual
Page 79

)(& ,QF
save and the (new) file number/ cycle number combinations are the same as those on the
disk, then the disk will be overwritten with the new information.
FIG. 7-13-3 DATA file utility (DATA Select) screen operation
A. FILE FORMAT : STATISTICS FORMAT (Data collection is based on this screen setup):
3-1a.
Move the cursor on the menu bar to [DATA SELECT] using the
[←]
[→]
keys and
depress the
[↵]
key. The Data Select window will appear. (Refer to Fig. 7-13-3)
3-2a.
Using the
[↑]
[↓]
keys, move the cursor to the desired display item. As each item is
accessed, it will become highlighted. To select the item, use the
[±]
key to add or
remove the [*] symbol from the column to the left of the item list. If the [*] symbol
appears next to an item, the item will be displayed.
3-3.a
After completing selection, depress the
[↵]
key and "DATA CHANGE OK Y/N?" will
appear. Select Yes or No using the
[←]
[→]
keys and depress the
[↵]
key to
finalize selection and exit from the Data Select window.
3-4a.
If information is being compiled on a diskette, then first insert a formatted diskette into
the Floppy Disk Drive (FDD). Depress the [SEL] key and the cursor will highlight the
[DRIVE] field. USE the
[←]
[→]
keys to select the desired drive.
3-5a.
AFTEr selecting the desired drive, use the alphanumeric pulldown menu to enter the
[PATH] and [FILE NAME] information. [PATH] must be either left blank, or set to an
existing directory name. When performing data file operations, the System will always
reference the root directory first and then the specified path. After entering the
information, select "INPUT END" from the menu and depress the
[↵]
key. The
entered information will appear in the applicable field(s) and the alphanumeric window
will close.
Chapter 7: System Operation
Page 7-79