FEC AFC1200 - Manual (Page 16)

)(& ,QF
6. Do not use REV3 on the final reject back-out. The use of this function will generate an
ACCEPT output that will override the fastening REJECT output.
7.1.6 Current Parameter Setup
The function of this screen is to preset the following parameters:
High Current [AMP]
High Warning [AMP]
Low Current [AMP]
Low Warning [AMP]
6-1 Select Input Mode
6-1a. Move the cursor on the menu bar to [INPUT MODE], select [CURRENT] and
depress the
[↵]
key. The screen displayed will be the "SET PARAMETER
(CURRENT)" screen. Check the Parameter Number to ensure that the correct
number has been selected. The screen will change to display the "SET
PARAMETER (CURRENT)" screen.
6-1b. Depress the [SEL] key and the cursor will move to the first position for
numerical entry.
FIG. 7-1-6-1 set parameter [CURRENT]
6-2 Input Current Parameter Data
6-2a. Enter the numerical data required for the selected item and depress the
[↵]
key.
Chapter 7: System Operation
Page 7-16