FEC AFC1200 - Manual (Page 11)

)(& ,QF
3-2. Select Tool Type
3-2a. Move the cursor to the [FULL SCALE TORQUE] position on the screen using
the
[↓]
key. The numerical value below [FULL SCALE TORQUE] will be highlighted.
DEPress the
[↵]
key and a pulldown menu will appear which displays the tool type
selection.
3-2b. Using the
[←] [→]
keys, scroll through the selection until the correct tool
type appears. DEpress the
[↵]
key and the highlighted full scale torque value will
change to that of the tool type selected. The pulldown menu will disappear.
NOTE: Refer to the "PREAMP EEPROM DATA" screen for the connected tool type.
FIG. 7-1-3-2 set parameter tool type selection
3-3. INPUT FASTENING PARAMETER DATA
3-3a. Use the
[↑] [↓]
keys to move the cursor to the desired fastening parameter.
Enter the numerical data, then depress the
[↵]
key. The data will be set and the
cursor will move to the next fastening parameter.
3-3b. WHen all data has been entered or changed, depress the [SEL] key. The
question "DATA CHANGE OK ?" will appear in the lower right hand corner of the
screen. NO will be highlighted as the default; to select YES to change the data, use
the
[←] [→]
keys and depress the
[↵]
key.
Refer to the "VOCABULARY LIST" Sections 7.1.7 Through 7.1.12 for details of
presetting for each fastening method and to Chapter 6 for fastening instructions.
FIG. 7-1-3-3 set parameter data presetting
3-4. SELECT CLEAR COMMand
3-4a. MOve the cursor on the menu bar to [CLEAR] using the
[←] [→]
keys and
Chapter 7: System Operation
Page 7-11