FEC AFC1200 - Manual (Page 67)

)(& ,QF
7.9.5 Screen Operation [System Configuration (3)]
5-1. After selecting [SYSTEM CONFIGURATION] from the menu bar, move the cursor on
the menu bar to [PAGE UP] or [PAGE DOWN] and depress the
[↵]
key until the
screen displays [SYSTEM CONFIGURATION (3)]. DEpress the [SEL] key. THe
screen will change to the set mode with the first item (FASTENING DATA PRINT
OUT : YES/NO) highlighted.
5-2. To change any of the nine (9) preset values for [SYSTEM CONFIGURATION (3)], the
item must first be selected using the
[↑] [ ↓ ]
keys. the
[←] [→]
keys are used to
select the desired value from the available options. after each item is set the
[↵]
must be pressed to confirm the setting prior to going to another item. (Refer to
Section 7.9.2.3 screen explanation for details of available settings.)
5-3. the configuration of the header and line format areas of System Configuration
screens (1), (2) and (3) is covered in Section 7.9.7.
5-4.
After completing all desired changes, depress the [SEL] key and the question "DATA
CHANGE OK?" will appear. Select YES or NO and depress the
[↵]
key.
FIG. 7-9-5 screen operation [SYSTEM CONFIGURATION (3)]
Chapter 7: System Operation
Page 7-67