FEC AFC1200 - Manual (Page 36)

)(& ,QF
3-1. Move the cursor on the menu bar to [SCALE] using the
[← ← ← ←] [→ → → →]
keys and depress the
[↵]
key. The Scale pulldown menu will appear with the cursor flashing at the first set
position.
3-2. There are four (4) selectable items as detailed below. Two (2) of the items relate to the
Torque/Angle curve and the other two (2) relate to the Torque/Time curve.
MSEC: (10,20,30,100,200,300)
(six settings available)
DEG: (0.1, 0.2, 0.3, 1, 2, 3)
(six settings available)
TIME DIVIDE ANGLE DIVIDE
MSEC: (range 10-500) DEG: (range 10-500)
TIME SCALE ANGLE SCALE
Note: Refer to Section 7.4.8 for details on how to set the scale.
FIG. 7-4-3 fastening curve scale selection
3-2a. The RUN/PROGRAM key does not have to be in the PROGRAM position to
enter data.
3-2b. Enter the numerical value for ANGLE SCALE, between 10 and 500 degrees,
using the numerical keys.
3-2c. Move the cursor to the next entry item using the
[↑] [↓]
keys and select the
desired DIVIDE (ANGLE) figure using the
[←] [→]
keys.
3-2d. Move the cursor to the next entry item using the
[↑] [↓]
keys and enter the
desired TIME SCALE numerical value using the numerical entry keys,
between 10 and 500 milliseconds.
3-2e. Move the cursor to the next entry item using the
[↑] [↓]
keys and select the
desired DIVIDE (TIME) figure using the
[←] [→]
keys.
3-2f. Depress the
[↵]
key and the screen will display the ANGLE SCALE and
DIVIDE (ANGLE) or the TIME SCALE and DIVIDE (TIME) values selected.
Note: If changes are made to this pulldown menu setup, the System must be cycled before the
Fastening Curve will display in accordance with the new parameters.
7.4.4 Data Base and Curve Type Selection
Chapter 7: System Operation
Page 7-36