GxT Ferret 54 ENGINE DIAGNOSTIC CENTER User Manual
Page 57
The
Electronic Compression
test is next. If the engine is DIS or if the Diagnostic Center is
unable to suppress the ignition, a screen will advise that the fuel must be disabled to prevent
the engine from starting during cranking.
After a reminder to switch off accessories, this screen will appear:
~ ELECTRONIC COMPRESSION
Crank Engine
243 RPM Battery 10.87 Volt
132 Amps
Crank the engine, with the ignition on, for about 8 seconds. The Diagnostic Center will show
when to stop cranking. Restore fuel, if disabled.
You will be given the option of creating a Visual Inspection Report. Follow the instruction below.
The AutoTest is now complete and the printout will begin. The last test run will be printed first,
so the report will read from top to bottom in the order tests were run.
PRINT SAVED DATA
Press REPORTS - AUTOTEST, SELECT
Print Saved Data
, and press NEXT. Whenever a
test is run, individually or as part of an AutoTest, the results are saved for review and printout.
The resulting printed report will include the most recent test readings along with any generated
diagnostic messages. If no tests have been done, a message will advise that no data is
available for printing. Disconnecting power will erase all saved data.
VISUAL INSPECTION
To help inform the car’s owner of additional service items that deserve attention, the condition
of many items, from tires and fan belts to wiper blades and lamps, can be indicated on the
Visual Inspection Report. This report is also available as part of the
AutoTest
.
Fluids
Tires
Cooling
Lamps
Battery
Brakes
Misc.
Use SELECT to move the cursor between categories. Press NEXT to see list of items in a
category. Then use SELECT to choose one of three line endings, OK, LOW or BAD. Press
NEXT to accept and move to the next item. A checkmark will appear to the left of each category
that has selected items. SELECT “Return to MENU” to return to the category list. SELECT
“Print”, and press NEXT to generate the report.
4-28