GxT Ferret 92 Color Labscope - Manual

1 www.gxtauto.com
Using 3rd Party Adapters ........................................... 8
LinkPort ...................................................................... 8
Setup Examples ....................................................9-11
Fuel Injector Volts ............................................... 9
Fuel Injector Volts & Amps ................................. 9
Fuel Pump Waveform ......................................... 9
Ignition Parade Pattern ..................................... 10
Single Cylinder Ignition ..................................... 10
Ignition KV, Fuel Injection, Primary Amps ......... 10
Oxygen Sensor ................................................. 11
TPS Sensor, Triggered ...................................... 11
TPS Sensor, Not Triggered ............................... 11
Using the Ignition Adapter ........................................ 12
Tips & Techniques .................................................... 13
Using Presets ........................................................... 14
Installing a new CF Card .......................................... 15
Labscope Tutorial ..................................................... 16
Using the USB Thumb Drive .................................... 23
© Copyright 2005, GxT, Inc., All Rights Reserved
OPERATOR’S MANUAL
VisionLink™ Color LabScope
92
Table of Contents
Test & Measurements Specifi cations ......................... 2
Inputs/Outputs ........................................................... 2
Display Information .................................................... 2
Physical Information ................................................... 2
Replacement Parts ..................................................... 2
Introduction ................................................................ 3
Kit Contents ................................................................ 3
Warranty ..................................................................... 3
Technical Support ....................................................... 3
Keypad ....................................................................... 4
Screen Layout ............................................................ 5
Turn Channels On and Off ..........................................
Turn Channels On and Off Turn Channels On and Off 5
Auxiliary Channel ........................................................ 5
Menu .......................................................................... 6
Trigger Modes ............................................................ 7
Cursors ....................................................................... 8
Using the Low Amps Probe ....................................... 8
Using the High Amps Probe ....................................... 8
Using the Battery Voltage Measurment ...................... 8