GxT Ferret 54 ENGINE DIAGNOSTIC CENTER - Manual (Page 21)

Collector
Bottle
ROAD TEST
Unplug and remove the Control Module and Gas Detector from the stand (leaving the exhaust
and drain hoses with the stand), and place them in the vehicle as shown below. Connect the
Gas Detector cable between the Gas Detector and the Control Module. Route the power and
RPM leads from underhood through a window. Secure the Sample Hose Assembly to the
vehicle with chain and route the sample hose to the Gas Detector. Make sure the Sample
Hose is kept clear of wheels and potential road obstacles. Connect the three black hoses on
the collector bottle to the exhaust and drain ports on the Gas Detector, and route the collector
bottle's center hose outside the vehicle, making sure it is not pinched or restricted.
Route Collector Bottle
center hose to outside
Route sample hose
across trunk and
away from wheels
Secure sample
probe to vehicle
with chain
Route leads
through window
and under hood
Route exhaust
and drain hoses
from Gas
Detector to
Collector Bottle
Place Gas
Detector
on floor
Operate Control
Module from
passenger seat
while assistant
drives vehicle.
Connect the three
Collector bottle exhaust
and drain hoses to the
Gas Detector, and route
the center hose outside
the vehicle
WARNING
Exhaust gas is toxic! All
exhaust and drain hoses
MUST be routed to the
outside.
2-8