Ohaus NBF1A2 Navigator Balances - Manual (Page 85)

22
TM
®
Print
Mode
Setup
Units
TM
Enter
On/Off
G/N/T
Zero Tare
4.7 Mode
The Mode menu permits the selection of four modes which can be turned ON or OFF. These modes are: Weigh,
Percent, Count, Checkweighing. Weigh is turned ON and all others have a default setting of OFF. When any of the
modes are turned ON, they can be selected for operation from the Mode button.
Procedure
• Press the Setup button, CAL is displayed.
• Press button until MODE is displayed.
• Press Enter button, WEIGH is displayed.
• Press Enter button.
• Press or button and select either ON or
OFF.
• Press Enter button to continue. Display advances to
PERCNT.
• Repeat above steps for PERCNT, COUNT and
CHECK.
• When EXIT appears on the display, press Enter
button to save setting.
Weigh
The Weigh menu is always set to ON as a default.
Percent
Percent weighing permits you to place a reference load on the balance, then view other loads as a percentage of the
reference. Selection is made using the Mode button. The default setting is OFF.
Count
Count is used for counting quantities of parts. Selection is made using the Mode button. The default setting is OFF.
Checkweighing
Checkweighing permits setting nominal weight, over weight and under weight values into the balance where individual
items must be checked against preset parameters. The default setting is OFF.
Setup
Use keys to change, press Enter
Change