Ohaus NBF1A2 Navigator Balances - Manual (Page 34)

34
4.7 Mode
The Mode menu permits the selection of five modes which can be turned ON or OFF. These modes are: Weigh,
Percent, Count, Animal Weighing, Checkweighing. Weigh is turned ON and all others have a default setting of OFF.
When any of the modes are turned ON, they can be selected for operation from the Mode button.
Procedure
• Press the Setup button, CAL is displayed.
• Press button until MODE is displayed.
• Press Enter button, WEIGH is displayed.
• Press Enter button.
• Press or button and select either ON or
OFF.
• Press Enter button to continue. Display advances to
PERCNT.
• Repeat above steps for PERCNT, COUNT, ANIMAL,
CHECK and LOCK.
• When EXIT appears on the display, press Enter
button to save setting. Balance returns to weighing
mode.
Weigh
The Weigh menu is always set to ON as a default.
Percent
Percent weighing permits you to place a reference load on the balance, then view other loads as a percentage of the
reference. Selection is made using the Mode button. The default setting is OFF.
Count
Count is used for counting quantities of parts. Selection is made using the Mode button. The default setting is OFF.
Animal weighing
Animal weighing provides special settings to compensate for animal movements. Selection is made using the Mode
button. The default setting is OFF.
Checkweighing
Checkweighing permits setting nominal weight, over weight and under weight values into the balance where individual
items must be checked against preset parameters. The default setting is OFF.
Lock
Lock ON/OFF can only be changed when the hardware Lock Switch is set OFF/disabled. A menu is locked when the
menu lock is set ON and the Lock Switch is ON. Lock when selected and turned on, locks all of the entries made
under the Mode menu. In the locked condition, items may be looked at but not changed in the menu. When set OFF,
entries may be changed. The default setting is OFF. Refer to paragraph 4.12 for Menu Lock-Out Protection.