Ohaus NBF1A2 Navigator Balances - Manual (Page 31)

31
4.5 Print
The Print menu provides a number of options which can be turned ON or OFF. It contains eight menus: Auto Print,
feature which includes selection of Off, Continuous, Interval and On Stability, Interval, specifies time interval for
automatic output of displayed data, Stable data-only feature, Numerical only or full display data for output, GLP
Continous, GLP Tare, Reference when selected prints reference weight value and Lock when set on enables you to
lock the settings. Refer to decriptions below and review settings before proceeding.
Procedure
• Press the Setup button, CAL is displayed.
• Press button until PRINT is displayed.
• Press Enter button to continue.
• Press or button until either AUTOPR,
INTER, STABLE, NUMERI, GLPCON, GLPTAR,
REF, LOCK or EXIT is displayed.
• Press Enter button to continue.
• Press or button and select either menu
settings of ON or OFF or settings shown below.
• Press Enter button to save setting.
• Press or button to select next item or EXIT.
• Press Enter button to continue.
Auto Print
When enabled, the Auto Print allows the balance to automatically output display data in one of three ways: continu-
ously, at user specified time intervals, or upon stability. Default setting is shown in bold.
OFF turns off auto print
Cont outputs data continuously
Inter provides a user specified output interval
On Stb provides data output everytime a stable reading is achieved
Interval
Can be set to provide a specified output interval between 1 and 3600 seconds.
Print Stable Data Only
When set On, permits only stable display data to be output. OFF is the default setting.
Print Numeric Data Only
When Numeric Data Only function is turned ON, allows the balance to output numeric data only for RS232 output.
OFF is the default setting.