beautypg.com

I-Data 5250 ALLY User Manual

Page 119

background image

Page 4-25

CHAPTER 4 — PROGRAMMABLE FUNCTION STRINGS

3E — LPAPER 3

Use paper from source/drawer 3. This PFS is sent to the printer at the

beginning of each landscape page when the System has sent an SCS Page

Presentation Media command with the sd parameter set to 03h. It uses

format information from Option 57 — Paper 3.

3F — L ENVEL

Use paper from source/drawer 4. This PFS is sent to the printer at the

beginning of each landscape page when the System has sent an SCS Page

Presentation Media command with the sd parameter set to 04h. It uses

format information from Option 58 — Envelope.

40 — LANDCUT

Use cut feed paper (sheet feed). PORTCUT and LANDCUT are the only

settings allowed by the System if the printer is configured as an IBM 3812

laser printer (!AGILE!02=00;). If the System specifies cut feed paper with

the SCS Set Printer Setup command, and if the printer is in landscape

mode, then this PFS will be sent to the printer. Afterward, one of the

drawer-select PFSs above will be sent to select the paper source drawer.

41 — LANDTRC

Use tractor feed paper. If the System specifies tractor feed with the SCS

Set Printer Setup command, and if the printer is in landscape mode, then

this PFS will be sent to the printer. If the printer has more than four paper

drawers, this PFS can be used to allow access to a fifth paper drawer.

However, automatic orientation selection works only for PFSs 35-38 and

3C-3F. It does not work for LANDTRC.

42 — LANDMAN

Use manual feed paper (sheet feed). If the System specifies manual feed

with the SCS Set Printer Setup command, and if the printer is in landscape

mode, this PFS will be sent to the printer. If the printer has more than four

paper drawers, this PFS can be used to access a fifth or sixth drawer.

However, automatic orientation selection works only for PFSs 35-38 and

3C-3F. It does not work for LANDMAN.