I-Data 5250 ALLY - Manual (Page 118)

AGILE 5250 ALLY User’s Guide and Reference Page 4-24
39 — PORTCUT
Use cut feed paper (sheet feed). PORTCUT and LANDCUT are the only
settings allowed by the System if the printer is configured as an IBM 3812
laser printer (!AGILE!02=00;). If the System specifies cut feed paper with
the SCS Set Printer Setup command, and if the printer is in portrait mode,
then this PFS will be sent to the printer. Afterward, one of the drawer-
select PFSs above will be sent to select the paper source drawer.
3A — PORTTRC
Use tractor feed paper. If the System specifies tractor feed with the SCS
Set Printer Setup command, and if the printer is in portrait mode, then this
PFS will be sent to the printer. If the printer has more than four paper
drawers, this PFS can be used to allow access to a fifth paper drawer.
However, automatic orientation selection works only for PFSs 35-38 and
3C-3F. It does not work for PORTTRC.
3B — PORTMAN
Use manual feed paper (sheet feed). If the System specifies manual feed
with the SCS Set Printer Setup command, and if the printer is in portrait
mode, then this PFS will be sent to the printer. If the printer has more than
four paper drawers, this PFS can be used to allow access to a fifth or sixth
paper drawer. However, automatic orientation selection works only for
PFSs 35-38 and 3C-3F. It does not work for PORTMAN.
3C — LPAPER 1
Use paper from source/drawer 1. This PFS is sent to the printer at the
beginning of each landscape page when the System has sent an SCS Page
Presentation Media command with the sd parameter set to 01h. It uses
format information from Option 55 — Paper 1.
3D — LPAPER 2
Use paper from source/drawer 2. This PFS is sent to the printer at the
beginning of each landscape page when the System has sent an SCS Page
Presentation Media command with the sd parameter set to 02h. It uses
format information from Option 56 — Paper 2.