I-Data 5250 ALLY - Manual (Page 106)

AGILE 5250 ALLY User’s Guide and Reference Page 4-12
If the printer is capable of printing any font at any pitch (CPI), then this
PFS should set the pitch for the current font. If a specific font is needed to
achieve 5 CPI, then this PFS should be defined to select that font.
If Option 4F — CPI/Font Order is set to 00 (!AGILE!4F=00;), then this
PFS will be sent before the GFID for the font is sent. If Option 4F — CPI/
Font Order is set to 01 (!AGILE!4F=01;), then this PFS will be sent after
the GFID for the font is sent.
11 — P 8CPI
Print 8 characters per inch in portrait orientation. This PFS is sent to the
printer when the 5250 ALLY’s page orientation algorithm has selected a
portrait orientation, and when the System has requested a font with a pitch
of greater than 5 but less than or equal to 8 CPI (using either an SCS Set
Character Density command or an SCS Set FID through GFID command).
If the printer is capable of printing any font at any pitch (CPI), then this
PFS should set the pitch for the current font. If a specific font is needed to
achieve 8 CPI, then this PFS should be defined to select that font.
If Option 4F — CPI/Font Order is set to 00 (!AGILE!4F=00;), then this
PFS will be sent before the GFID for the font is sent. If Option 4F — CPI/
Font Order is set to 01 (!AGILE!4F=01;), then this PFS will be sent after
the GFID for the font is sent.
12 — P 10CPI
Print 10 characters per inch in portrait orientation. This PFS is sent to the
printer when the 5250 ALLY’s page orientation algorithm has selected a
portrait orientation, and when the System has requested a font with a pitch
of greater than 8 but less than or equal to 10 CPI (using either an SCS Set
Character Density command or an SCS Set FID through GFID command).
If the printer is capable of printing any font at any pitch (CPI), then this
PFS should set the pitch for the current font. If a specific font is needed to
achieve 10 CPI, then this PFS should be defined to select that font.
If Option 4F — CPI/Font Order is set to 00 (!AGILE!4F=00;), then this
PFS will be sent before the GFID for the font is sent. If Option 4F — CPI/
Font Order is set to 01 (!AGILE!4F=01;), then this PFS will be sent after
the GFID for the font is sent.