HP B180L - Manual (Page 202)

188
SCSI Connections
Assigning SCSI Device IDs
CAUTION: Do not use SCSI device ID 7 for any device.
Ultra, Wide-SE SCSI IDs
Before assigning a SCSI device ID to your drive, you need to check your
SCSI device IDs. To check which SCSI device IDs are available and assign
an ID to your device, follow these instructions which use Table 26.
1 Write in the type of internal drives currently connected to your system under the
heading “Ultra SCSI Device Drives” and each drive’s SCSI device ID under the
heading “Device ID.”
2 Add your new drive to the table.
3 Check to see what SCSI device IDs are not used. You may use ID numbers 0
through 6 and 8 through 15 if they are not already in use. If the default ID on your
drive does not conflict with any existing drive IDs, use that ID. If your default
address conflicts with an existing drive ID, assign a new ultra, wide single-ended
SCSI device ID to your drive. Refer to the drive’s installation documentation for
information on changing the device ID.
Table 26 Fast, Wide SCSI Device Drives and Device ID
Fast, Wide SCSI Device Drives
Device ID (Address) Number (ID 7
not available)
1st Internal Device _____________________________ _____________________________
2nd Internal Device ____________________________ _____________________________
NOTICE: You can have no more than 15 SCSI devices connected to a fast, wide bus.