HP B180L - Manual (Page 174)

160
Changing Your Workstation’s Hardware Configuration
Replacing the Battery
12 Reconnect the floppy, SE SCSI, power, CD-ROM audio, and FW SCSI cables as
shown in Figure 62.
When connecting the floppy cable to the system board, use the following proce-
dure:
a Lift the locking ring on the connector to the up, or unlocked, position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector with the locking ring.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
Figure 62 Connecting the Storage Tray Cables
13 Follow the instructions in Replacing the Main Tray Assembly on page 112.
Floppy Connector
SESCSI
Storage Tray
CD Audio
Power
FWSCSI