HP B180L User Manual
Page 177
163
Changing Your Workstation’s Hardware Configuration
Installing the Optional Fast Wide Differential SCSI Controller
Installing the Optional Fast Wide Differential SCSI
Controller
Before you can install the FWD SCSI controller (B132L/B160L only) you
must perform the procedure described in Removing the Main Tray Assem-
bly on page 111.
NOTE:
You cannot use both the Ultra, Wide-SE SCSI and the Fast Wide Differential
SCSI option at the same time.
Perform the following procedure to install the FWD SCSI controller:
1
Install the three standoffs, as shown in Figure 64.
2
Line up the connector on the FW SCSI controller and the connector on the CPU
board while at the same time aligning the standoffs to the holes in the FWD SCSI
controller, as shown in Figure 64.
Figure 64
Installing the Optional FWD SCSI Controller