HP B180L - Manual (Page 144)

130
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
9 Connect the cable to the floppy drive.
When connecting the floppy data cable, use the following procedure, as shown
in Figure 37:
a Lift the locking ring on the connector to the up, or unlocked, position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector until the blue line is even with the locking ring.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
Figure 37 Connecting the Floppy Drive Data Cable
10 Proceed to the section entitled Replacing the Storage Tray Cover on page 132.