Removing the main tray assembly – HP B180L User Manual
Page 125
111
Changing Your Workstation’s Hardware Configuration
Removing the Main Tray Assembly
Removing the Main Tray Assembly
Perform the following steps to remove the Main Tray Assembly:
1
Shutdown and prepare the workstation as described in Preparing Your Worksta-
tion earlier in this appendix.
2
Disconnect all cables and connectors from the front and rear connectors of the
system unit.
3
Attach a static-grounding wrist strap to bare metal on the back panel of the system
unit.
4
Remove the four thumbscrews on the rear of the system unit, as shown in Figure
21.
Figure 21
Removing Main Tray Assembly
5
Place one hand on the top of the system unit and push, while pulling the handle
on the rear panel with your other hand. See Figure 21.
6
Slide the main tray assembly out of the chassis.
Thumbscrews
Thumbscrews