HP B180L - Manual (Page 165)

151
Changing Your Workstation’s Hardware Configuration
Installing a PCI, EISA, or GSC Option Board
Installing the Option Board
Before installing option boards you must perform the procedure described in
Removing the Main Tray Assembly on page 111.
Follow these steps to install a PCI, EISA, or GSC option board into your
workstation:
1 Push in the locking tab and slide the option board support bracket toward the rear
of the main tray to remove it, as shown in Figure 53.
2 Remove the blank plate retaining screw, then remove the blank plate, as shown
in Figure 53.
Figure 53 Removing the Option Board Support Bracket and Blank Plate
Blank Plate
Support Bracket