HP B180L User Manual
Page 136
122
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
2
From the front of the storage tray, line up the slides on the CD-ROM or DDS tape
drive with the slots in the storage tray, and slide it into place, as shown in Figure
29.
Figure 29
Installing a CD-ROM or DDS Tape
3
Push the CD-ROM or tape drive in about half way.
4
Connect the single-ended SCSI data cable and the power cable to the drive.
5
Push the drive in all of the way until you hear and feel the slides snap into place
6
Connect the CD-ROM audio cable to the CD-ROM drive.
7
Feed the CD-ROM audio cable out of the storage tray opening.
8
Proceed to the section entitled Replacing the Storage Tray Cover on page 132.