HP N1200-320 User Manual
HP Hardware
Table of contents
Document Outline
- Contents
- Introduction
- Installation, cabling, and setup
- Identifying product components
- Typical installation configuration tasks
- Installing the HP N1200-320 4Gb Network Storage Router
- Setting up serial port communications
- Cabling the N1200-320 4Gb Network Storage Router
- Device management
- N1200-320 4Gb Network Storage Router management
- Visual manager user interface
- Visual manager access
- Main menu
- System menu
- Ports menu
- Discovery menu
- Mapping menu
- Statistics menu
- Utilities menu
- Report menu
- Reboot option
- Using the Command Line Interface
- Power-up messages
- Perform configuration
- Figure 38 Configuration menu
- Baud rate configuration
- Ethernet configuration
- Fibre Channel configuration
- Parallel SCSI configuration
- Device mapping
- Trace and event settings configuration
- Real-Time clock configuration
- Active fabric configuration
- Save configuration
- Restore last saved configuration
- Reset to factory defaults
- System utilities
- Display trace and assertion history
- Reboot
- Download a new revision of the firmware
- Using the FTP interface
- Troubleshooting
- General troubleshooting
- Indicators
- Basic verification
- Pin assignments
- Regulatory compliance and safety
- Inband SCSI-3 commands
- Addressing, structures, and operations
- Enabling DHCP on the HP N1200-320 4Gb Network Storage Router
- Index