HP N1200-320 - Manual (Page 60)

60 Using the Command Line Interface
The main menu allows for various operations to be performed on the network storage router.
• Select 1 to access network storage router configuration settings.
• Select 2 to access System Utilities.
• Select 3 to display trace and assertion history.
• Select 4 to reboot the network storage router. A confirmation message appears to verify this action.
• Enter N to return to the System Utilities menu.
• Enter Y to restart the network storage router.
• Select 5 to download a new revision of the firmware. A confirmation message appears to verify this
action. (For additional information see ” Download a new revision of the firmware ” on page 90.)
• Enter N to return to the Main menu.
• Enter Y for the network storage router to accept firmware data from the serial port.
Perform configuration
The Perform Configuration menu allows the administrator to configure the various options on the network
storage router. For most configuration changes to take effect, you must reboot the network storage router.
NOTE: Menus are not case sensitive. You can enter uppercase and lowercase characters
interchangeably, whenever menus indicate letters as choices.
Figure 38 Configuration menu
Configuration Menu
X.XX.XX XXXXXX XXXXXXXXXXXXXXXX
07/7/2005 08:56:22
1) Baud Rate Configuration
2) Ethernet Configuration
3) Fibre Channel Configuration
4) Parallel SCSI Configuration
5) Device Mapping
6) Trace and Event Settings Configuration
7) Real-Time Clock Configuration
8) Active Fabric Configuration
A) Save Configuration
B) Restore Last Saved Configuration
C) Reset to Factory Defaults
X) Return to main menu