HP N1200-320 - Manual (Page 64)

64 Using the Command Line Interface
Fibre Channel configuration
This menu allows for setting the Fibre Channel Address method, Hard Address value, discovery mode,
WWN overrides, tape backup settings, default map value, and FC port mode.
Figure 41 Fibre Channel configuration menu
NOTE: For In-Band Management to be operational, WWN naming schemes must be compliant with IEEE
Fibre Channel Format 1, where the left-most hexadecimal character (the NAA field) of the WWN is 1.
Further, the upper nibble of the third byte (the sixth hexadecimal value from the right) must be a value of 0
or 1.
• Select 1 to enter a new value for the World Wide Name High. Ordinarily, this value should not be
changed.
NOTE: Resetting factory defaults overwrites any value a user has previously manually entered for the
WWN.
• Select 2 to enter a new value for the World Wide Name Low. Ordinarily, this value should not be
changed.
NOTE: Resetting factory defaults overwrites any value a user has previously manually entered for the
WWN.
Fibre Channel Configuration Menu
X.XX.XX XXXXXX XXXXXXXXXXXXXXXX
07/7/2005 08:56:22
Current Fibre Channel Configuration - Port 0:
FC Link Status : DOWN
Node Name : 0x100000E0 02031751
Port Name : 0x100000E0 02231751
Port Mode : N_Port Mode
Discovery Mode : Manual Discovery Only
Buffered Tape Writes : Enabled, Queue Depth = 5
Current Default Map : 'Indexed'
Port Speed : 2 GigaBit
1) Change World Wide Name High 2) Change World Wide Name Low
3) Toggle Port Mode 4) Change ALPA Value
5) Toggle Discovery Mode 6) Toggle Buffered Tape Writes
7) Change Buffered Tape Queue Depth 8) Change Default Map Value
9) Edit FC Override Settings
A) Toggle Port Speed
X) Return to previous menu
Command >