Updating firmware – HP N1200-320 User Manual
Page 93
N1200-320 4Gb Network Storage Router user and service guide
93
• For the current event log, use get eventlog.txt.
The file will transfer to the current directory specified on your computer’s FTP utility. If running FTP from
a DOS or Linux command line, the destination directory can be set using the lcd command (ex. lcd
c:\myCfg
).
Updating firmware
Using the following procedure, FTP can be used to update the network storage router firmware.
1.
Connect the network storage router to the Ethernet network used by your computer.
2.
Start your FTP program using the network storage router’s IP address:
ftp <IP address>
IMPORTANT:
The network settings set to use DHCP need to be set to default. If the IP address is not
known, use the serial interface to obtain the network settings. See ”
Setting up serial port communications
NOTE:
If the network storage router is to use a static IP address, the pre-filled in address when DHCP is
disabled is 1.1.1.1 and should be changed to an address that is appropriate for the IP network it will
reside on.
3.
Enter the user name and password. The default values for user name and password are root for the
user name and password for the password.
4.
Specify binary mode:
bin
5.
Specify the firmware’s path and filename (.dlx file) with the put command:
put <path\filename.dlx>
The file will transfer and the network storage router will reboot. The network storage router will then be
using the new firmware.
NOTE:
You may want to confirm the new firmware level by checking the reboot messages on the
network storage router through the serial interface.