HP N1200-320 - Manual (Page 68)

68 Using the Command Line Interface
SCSI initiator menu
This option allows for setting up the SCSI Initiator.
Figure 43 SCSI initiator menu
• Select 1 to select the primary SCSI Initiator ID. This is the ID for the SCSI device that requests operations
from other SCSI devices known as targets. This should be a unique ID on the bus. This value is initially
blank and the user must enter an integer value in the range of 0-15 prior to saving the configuration to
the network storage router.
• Select 2 to enable/disable an alternate SCSI Initiator ID.
• Select 3 to select an alternate SCSI Initiator ID. This should be a unique ID on the bus. The default value
is 6. This option is used to enhance the performance of status (agent) commands issued to a serial
device.
SCSI Initiator Menu
X.XX.XX XXXXXX XXXXXXXXXXXXXXXX
07/7/2005 08:56:22
Current Initiator Configuration - Bus 0
Initiator ID : 07
1) Select primary SCSI Initiator ID
2) Enable/Disable alternate SCSI ID
(The "alternate" ID is used to enhance the performance
of status ("agent") commands that are being issued to a
serial device. To use this feature enable the alternate
ID and pick an ID that is currently unused on this bus.)
3) Select alternate SCSI Initiator ID
X) Return to previous menu