Hitachi 8450H/R - Manual (Page 115)

Ch 4: System Environment Settings
Hitachi PC VisionBase 8450H/R Server 111
Message: Boot ROM will not install: Incompatible SDMS 3.X version
Explanation: BIOS version 3.XX.XX had already been loaded before version 4.XX.XXwas loaded.
Update it to version 4.XX.XX.
Message: ERROR! The PCI System BIOS is NOT present
Explanation: There is no PCI system BIOS. The system has a problem in a portion other than this board.
Message: INVALID serial EEPROM dataÅCserial EEPROM was ....
Explanation: Incorrect data has been detected within NVRAM. The data is rewritten to the initial value by
BIOS.
Message: ERROR! This adapter is malfunctioning
Explanation: The board operated abnormally. The board might be faulty.
Message: Bus Master ERROR
Explanation: The controller chip on the board operated abnormally. The controller chip might be faulty.
Message: Warning! IO address not enabled
Explanation: The PCI system BIOS has not assigned any I/O address to the board. The system has a
problem in a portion other than this board.
Message: Failed to add deviceÅCtoo many devices
Explanation: Too many SCSI devices are to be connected. Up to 24 SCSI devices can be connected.
Message: Calculated number of heads is too large!
Explanation: The header size of the drive’s boot partition block is incorrect.
Message:
Explanation: The boot partition block of the drive has an incorrect signature.
Message:
Explanation: The boot partition of the drive has been destroyed.
Message:
Explanation: The boot partition of the drive has been destroyed.
Message:
Explanation: The boot partition of the drive has been destroyed.
Message: Failed to add deviceÅCtoo many devices!
Explanation: Too many devices are to be controlled by INT13.
Message: ERROR in serial EEPROM data, serial EEPROM was...
Explanation: Data in EEPROM has been destroyed.