Panasonic KX-TD500 User Manual
Page 20
Configuration
20
Programming Guide
Save the data changes by clicking "Apply" button.
Then set "Port Status" to "INS (In-Service)."
Jack No.1 must be assigned, because the port is used as the channel to control the VPS.
5. Synchronisation of the communication between the KX-TD500 System and the TVP.
The KX-TD500 System begins synchronisation with the VPS when the step 4 is done.
The "Power" LED of the VPS begins flashing at the same time. The LED will turn on after the
synchronisation is completed. It takes for about 30 seconds to 1 minute to be able to use the
VPS system. It depends on the VPS model and the port number you set up.
Parameter
TVP No.
Default
1
Value Range
1- 8
Description/Function
Specifies one of the Panasonic Voice Processing Systems (VPSs)
connected to the KX-TD500 system, which you are going to
programme.
Reference
• 1.3 System Features (F/G)
– Integration, VPS
• 1.2 Slot Assignment (P/G)
Parameter
VPS Card
Default
None
Value Range
None, XXX : YYY [XXX : Card No. (101-314), YYY : Card Type]
Description/Function
Specifies the physical number of DLC / DHLC card to which VPS
is connected as extensions.
Note
•
The first DLC / DHLC card will support jacks 1 to 8 of the
first TVP300 system. A second card will support jacks 9 to
12 of the TVP300 system. A third and fourth card are needed
to support a second TVP300 system which is fully
configured.
Reference
• 1.3 System Features (F/G)
– Integration, VPS
• 1.2 Slot Assignment (P/G)