HP 0706124 REV B - Manual (Page 25)

Unpacking and Assembly 1-13
21. Install the service station by inserting it into the rectangular
cutout inside the right endcap (behind the control panel).
Position the service station so that the edge with the word
“FRONT” is closest to the front of the printer. Slide the ser-
vice station fully to the left end of the cutout.
22. Join the connector on the twisted wires from the takeup
motor to the connector on the electronics assembly.
The connector on the electronics assembly is on the side of
the electronics enclosure, near the takeup spool bracket.
Connecting to Power The printer has separate power inputs for the printer and dryer
heaters. Each cord will only fit into its corresponding inlet on
the printer. The printer can be operated with one or both inlets
connected to power. See Appendix A, Technical Specifications,
or refer to the Site Preparation Guide, for detailed power require-
ments.
Refer to Fig. 1-8 for the locations of the printer power inlets.
The print server may be connected to the same circuit as the
printer if the circuit’s amperage is sufficient for both devices.
Refer to the print server’s documentation for its amperage
requirement. Consult a qualified electrician if you have any
doubt as to how the circuits in your facility can accommodate
the printer and print server.
WARNING WITH THE POWER SWITCH IN THE OFF POSITION,
POWER MAY STILL BE SUPPLIED TO THE PRINTER
COMPONENTS. To completely cut power from the
printer, you must unplug the power cords from the
power outlets.
WARNUNG WENN DER NETZSCHALTER IN OFF POSITION
STEHT, WIRD DEN KOMPONENTEN TROTZDEM
STROM ZUGEFÜHRT. Um den Drucker komplett
stromfrei zu machen, müssen Sie den Netzstecker
ziehen.