HP 0706124 REV B - Manual (Page 108)

4-20 AutoTune
AutoTune
AutoTune runs AutoSet automatically at intervals you specify.
When you use the AutoTune scheduler to run AutoSet, AutoSet
always performs its three calibrations without prompting the
user or canceling due to too many bad jets. You can use the
Quality Check Mode feature to handle AutoSet errors, with or
without user intervention.
To run AutoSet at specified intervals (AutoTune):
1. On the Front Page screen, press the v (Menu) key to enter
the menu system.
2. Press the E (Menu In) key display the Calibrate Printer
menu.
3. Press the
p key to highlight AutoTune.
4. Press the E (Menu In) key.
The control panel prompts you to specify an AutoTune
interval.
5. Press
B (Proceed).
The control panel displays this message:
Run AutoSet every 0 prints.
6. Press the
C key repeatedly to increment the AutoTune inter-
val to the number of prints you desire.
7. Press
B (Proceed).
8. Press the
z (Menu Out) key repeatedly until the Front Page
screen is displayed. Press the Online/Offline button to return
the printer to the Ready state.
Quality Check Mode When you run AutoSet manually, the software notifies you if
there are any jet or alignment problems so that they can be
addressed. When AutoTune runs AutoSet at scheduled intervals,
you can use the Quality Check Mode feature to handle AutoSet
errors. For instructions on setting the Quality Check Mode, see
page 2-13.