HP 0706124 REV B - Manual (Page 140)

B-8 Diagnostics
A-TU-2 - Takeup Stall The takeup motor has stalled. Check for mechanical interference or
binding, overloaded spool, out of
balance spool, or failure in electron-
ics or motor.
W-TU-1 - Takeup Nearly Full The media takeup spool is almost
full. Unload the takeup spool and reload
media (page 3-24).
W-TU-2 - Takeup Connected - Slip-
ping The media takeup core is slipping. Reload the media (page 3-24).
W-TU-3 - Takeup not Loaded Takeup Mode ON, but takeup spool
is not loaded. Load takeup (page 3-24) or turn
Takeup Mode OFF (page 2-11).
(VN) VideoNet
W-VN-1 - VideoNet not Connected The printer cannot detect a print
server. Connect cable, turn on ser ver, add
printer to server.
(WP) White Point
A-WP-1 - White Point Drift Too Large Image sensor white point is invalid. Clean LEDs and white point chip.
W-WP-1 - White Point Drift Detected Image sensor white point is varying. Clean LEDs and white point chip.
W-WP-2 - White Point Chip Missing The image sensor white point chip
cannot be seen. Install/clean white point chip, or call
Tech Support.
Table B-1. Actions and Warnings