beautypg.com

Mobile home - additional installation requirements, Cabinet dimensions – KITCHENAID 30 Inch Slide-In Induction Range Owners Guide User Manual

Page 8

background image

Mobile Home - Additional Installation

Requirements

The installation of this range must conform to the Manufactured

Home Construction and Safety Standard, Title 24 CFR, Part 3280

(formerly the Federal Standard for Mobile Home Construction and

Safety, Title 24, HUD Part 280). When such standard is not

applicable, use the Standard for Manufactured Home Installations,

ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this range must conform with the

current standards CAN/CSA-Z240.1-latest edition, or with local

codes.

Mobile home installations require:

When

this

range

is

installed

in

a

mobile

home,

it

must

be

secured

to

the

floor

during

transit.

Any

method

of

securing

the

range

is

adequate

as

long

as

it

conforms

to

the

standards

listed

above

.

Four-wire

power

supply

cord

or

cable

must

be

used

in

a

mobile

home

installation.

The

appliance

wiring

will

need

to

be

revised.

See

“Electrical

Connection

-

U.S.A.

Only”

section.

Cabinet Dimensions

Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm)

countertop height.

IMPORTANT:

If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood

combination installation instructions for dimensional clearances above the cooktop surface.
Range may be installed next to combustible walls with zero clearance.

NOTE:

When installed in a slide-in cutout, the front of oven door may protrude beyond the base cabinet.

Slide-In Cutout

Freestanding Cutout

J

C

B

A

D

F

G

H

I

E

H

K

J

C

B

A

D

F

G

H

I

E

H

A.

For minimum clearance to top of cooktop, see NOTE*.

B.

30" (76.2 cm) minimum opening width

C. 13" (33 cm) maximum upper cabinet depth
D. 30" (76.2 cm) minimum opening width
E.

The shaded area is recommended for installation of rigid gas pipe and
grounded outlet.

F.

13

1

8

" (33.3 cm)

G. 7

11

16

" (19.5 cm)

H. 4

13

16

" (12.2 cm)

I.

3

11

16

" (9.4 cm) plus measurement of M

J.

Cabinet door or hinges should not extend into the cutout.

K.

Remaining counter depth should not exceed 2

1

4

" (5.7 cm).

A.

For minimum clearance to top of cooktop, see NOTE*.

B.

30" (76.2 cm) minimum opening width

C. 13" (33 cm) maximum upper cabinet depth
D. 30" (76.2 cm) minimum opening width
E.

The shaded area is recommended for installation of rigid gas pipe and
grounded outlet.

F.

13

1

8

" (33.3 cm)

G. 7

11

16

" (19.5 cm)

H. 4

13

16

" (12.2 cm)

I.

3

11

16

" (9.4 cm)

J.

Cabinet door or hinges should not extend into the cutout.

NOTE:

24" (61.0 cm) minimum when bottom of wood or metal cabinet is shielded by not less than 1/4" (0.64 cm) flame retardant

millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020"

(0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.

8