beautypg.com

Adjust leveling legs, Warning – KITCHENAID 30 Inch Slide-In Induction Range Owners Guide User Manual

Page 11

background image

4.

Drill two 1/8" (3 mm) holes that correspond to the bracket

holes of the determined mounting method. See the following

illustrations.

Floor Mounting

Rear Position

Front Position

Diagonal (2 options)

Wall Mounting

5.

Using the two #10 x 1

5

/

8

" (4.1 cm) Phillips-head screws

provided, mount anti-tip bracket to the wall or floor.

6.

Move range close enough to opening to allow for final

electrical connections. Remove shipping base, cardboard or

hardboard from under range.

7.

Move range into its final location, making sure rear leveling leg

slides into anti-tip bracket.

8.

Move range forward onto shipping base, cardboard or

hardboard to continue installing the range using the following

installation instructions.

Adjust Leveling Legs

1.

If range height adjustment is necessary, use a wrench or pliers

to loosen the four leveling legs.
This may be done with the range on its back or with the range

supported on two legs after the range has been placed back to

a standing position.

NOTE:

To place range back up into a standing position, put a

sheet of cardboard or hardboard in front of range. Using two

or more people, stand range back up onto the cardboard or

hardboard.

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation

instructions.
Slide range back so rear range foot is engaged in the

slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed

and engaged.
Failure to follow these instructions can result in death or

serious burns to children and adults.

2.

Measure the distance from the top of the counter to the floor.

3.

Measure the distance from the top of the cooktop to the

bottom of the leveling legs. This distance should be the same.

If it is not, adjust the leveling legs to the correct height. The

leveling legs can be loosened to add up to a maximum of

1" (2.5 cm). A minimum of 3/16" (5 mm) is needed to engage

the anti-tip bracket.

NOTE:

If height adjustment is made when range is standing,

tilt the range back to adjust the front legs, and then tilt forward

to adjust the rear legs.

4.

When the range is at the correct height, check that there is

adequate clearance under the range for the anti-tip bracket.

Before sliding range into its final location, check that the

anti-tip bracket will slide under the range and onto the rear

leveling leg prior to anti-tip bracket installation.

NOTE:

If a Trim Kit will be used, the top of the cooktop should

be higher than the counter. See the Installation Instructions

included with the Trim Kit for the correct height.

11