9 caution, Risk of pinching, Replacing an cven light – Bosch 800 Series 30 Inch Freestanding Dual Fuel Range Use and Care Manual User Manual
Page 30: When replacing an oven light, Allow the cooking compartment to cool down, Open the appliance door, Place a cloth in the oven cavity to prevent damage, Remove the racks and rack guides, Remove the oven light bulb, Replace the glass cover for the oven light bulb
30
(203 mm). This takes the tension off the spring-loaded
hinges so that the door can be easily lifted out.
9
CAUTION
RISK OF PINCHING
Closing the door by 8" (203 mm) takes the
pressure off the spring. If this is not done, the
door can still be removed but the latch will now
slam shut and will pinch or cut your hand.
4.
The door is heavy. Use both hands to firmly grip it by
the sides. Do not grip the door by the handle. Keeping
the angle of the door the same, lift the door straight up
approximately 3/4" (19 mm) to unhook the hinges
from the slots, and then pull it out towards you until the
hinges are clear of the oven housing.
5.
Place the door in a convenient and stable location for
cleaning.
6.
Refit the door in the reverse order in which it was
removed.
Replacing an Cven Light
9
CAUTION
WHEN REPLACING AN OVEN LIGHT:
▯
Make sure the appliance and lights are cool and
that the power to the appliance has been turned
off before replacing the light bulb(s). Failure to do
so may result in electrical shock or burns.
▯
Wear gloves.
▯
The lenses must be in place when using the
appliance.
▯
The lenses serve to protect the light bulb from
breaking.
▯
The lenses are made of glass. Handle carefully to
avoid breaking. Broken glass may cause an
injury.
▯
The light socket is live when the door is open.
Bulb specifications:
Voltage:
120
V;
Power:
40 W;
Fitting:
G9;
Temperature resistance:
575°F (300°C)
To change the bulb:
1.
Allow the cooking compartment to cool down.
2.
Open the appliance door.
3.
Place a cloth in the oven cavity to prevent damage.
4.
Remove the racks and rack guides.
5.
Remove the glass cover. To do this, open the glass
cover at the front with your hand. Should you
experience difficulties removing the glass cover, use a
spoon to help.
6.
Remove the oven light bulb.
7.
Replace the oven light bulb with a bulb of the same
type.
8.
Replace the glass cover for the oven light bulb.
9.
Replace rack guides and racks.
10.
Remove the cloth.
11.
Switch the circuit breaker back on.
12.
Check that the oven lighting is working again.
´