beautypg.com

Cleaning self-cleaning surfaces, 9 caution, Set the bake burner to the highest temperature – Bosch 800 Series 30 Inch Freestanding Dual Fuel Range Use and Care Manual User Manual

Page 28: Press w to switch on air recirculation, Switch off the appliance after one hour, Note, Rinse and dry the self-cleaning surfaces, Set the bake burner to 350°f, Maintenance, How to remove the oven door glass

background image

28

Cleaning Self-cleaning Surfaces

9

CAUTION

Do not use oven cleaner on the self-cleaning

surfaces. These will damage the surfaces. If oven

cleaner does get onto these surfaces, dab it off

immediately using water and a sponge cloth. Do not

rub the surface and do not use abrasive cleaning

aids.

1.

Use a microfiber cloth with soapy water to clean the

upper and lower part of the self-cleaning surfaces.

2.

Set the bake burner to the highest temperature.

3.

Press

w

to switch on air recirculation.

4.

Switch off the appliance after one hour.

5.

If the side, self-cleaning surfaces are particularly dirty,

remove these from the cooking compartment.

Note:

The self-cleaning surface on the back panel

must remain in the cooking compartment.

6.

Wash the self-cleaning surfaces with hot soapy water.

7.

Rinse and dry the self-cleaning surfaces.

8.

Insert the self-cleaning surfaces into the cooking

compartment.

9.

Set the bake burner to 350°F.

10.

Press

w

to switch on air recirculation.

11.

Switch off the appliance after one hour.

Maintenance

How to Remove the Rack Guides and Self-cleaning

Surfaces

The rack guides are fixed to the side panels of the

cooking compartment at three points. The self-cleaning

surfaces are fixed with the rack guides.

1.

When the oven is cool, grip the front of the rack guide

and pull it round to the middle of the cooking

compartment.
The front hook of the rack guide will come out of the

hole.

2.

Swing the rack guide round further and pull it out of

the rear holes in the side panel.

3.

Remove the rack guides from the cooking

compartment.

4.

Replace the self-cleaning surfaces and rack guides in

the reverse order in which they were removed.

How to Remove the Oven Door Glass

9

WARNING

Make sure oven is cool and power to the oven

has been turned off before removing the door.

Failure to do so could result in electrical shock or

burns.

The glass panels are big, heavy and parts are

fragile. Use both hands to remove the glass.

Handle carefully to avoid breakage.

Failure to grasp the glass firmly and properly

could result in personal injury or product damage.

Do not place the glass on sharp or pointed

objects as this could break the glass. Lay on a

flat, smooth surface, positioned so that the glass

cannot fall over.

9

CAUTION

Wear gloves to avoid cutting fingers on broken

glass.

For easier cleaning the internal glass panes of the door

can be removed.

1.

Open the oven door fully.

2.

Lock the two hinges on the left and right using the

locking pin.The locking pins must be fully inserted into

the holes in the hinges.

3.

Remove the internal glass pane by pulling the rear part

gently upwards, following the movement indicated by

the arrows (1). This way, the first 2 pins attached to the

rear of the glass detach from their housings in the

oven door. Then, push the glass pane slightly towards

the cooking compartment and pull it upwards (2). This

way, the other 2 pins attached to the front of the glass

detach from their housings in the oven door.

D

E

This manual is related to the following products: