Bosch 800 Series 30 Inch Freestanding Dual Fuel Range Use and Care Manual - Manual (Page 10)

10
Checking Burner Cap Placement
Check to make sure that there is no gap between the
burner cap and burner base. See illustration below for
correct and incorrect placements of the burner cap.
You may gently try to move the burner cap from side to
side to check if it is properly placed. If properly placed,
the cap will click from side to side as the prongs hit the
groove ridge.
Install Grates
First position the outer grates, followed by the the central
grate. If you only have two grates, the order in which you
position them is not relevant.
Inserting Racks
9 CAUTION
▯
To avoid burns, place oven racks in desired
positions before turning oven on. Always use
oven mitts when the oven is warm. If a rack must
be moved while the oven is hot, do not let oven
mitts contact hot heating elements.
▯
Use caution when removing oven racks from the
lowest rack position to avoid contact with the hot
oven door.
▯
To avoid possible injury or damage to the
appliance, ensure racks are installed exactly per
installation instructions and not backwards or
upside down.
The wire rack can be inserted into the cooking
compartment at six different levels. Always push
accessories in fully so that they do not touch the door
panel. Make sure that you always insert the accessories
into the cooking compartment the right way round.
Flat Rack
The rack is designed with a stop so it will stop before
coming completely out of the oven and not tilt.
To insert wire rack into oven:
1. Grasp rack firmly on both sides.
2. Insert rack (see picture).
3. Tilt rack up to allow stop into rack guide.
4. Bring rack to a horizontal position and push the rest of
the way in.
Rack should be straight and flat, not crooked.
To remove Flat Rack from Oven:
1. Grasp rack firmly on both sides and pull rack toward
you.
2. When the stop is reached, tilt rack up and pull the rest
of the way out.
D
D